地磁力冷凝器出廠前要開展相關的滾壓開展實驗的主要目的是檢查超高壓冷凝器相關使用性能及更為安全性，其更加具體發展同時為： 地磁力冷凝器做滾壓開展實驗的固體為索然無味進行除去的大氣、氮氣或關於別的惰氣性體。開展實驗同時中應該具備更為安全具體措施，開展實驗機構的更為安全進行管理單位應該在工作現場開展開展監督進行管理。地磁力冷凝器做滾壓開展實驗同時如下：開展實驗時應先緩緩升溫至平整開展實驗壓強的10%，保壓5毫秒後，對更加所用銲接搭接片盒連接位置開展檢查。在予以確認以上位置並未泄露後，保持連續進行升溫至平整開展實驗壓強的50%。
以上同時中平等常要樣兒，這之後按平整開展實驗壓強的10%逐漸升溫，截至開展實驗壓強，保壓10毫秒。到最後將至超高壓冷凝器的設計壓強，保壓符合時間開展檢查，檢查時期其壓強應持續堅持進行穩定，如持續有變化證明超高壓冷凝器中有漏氣位置，應進行檢查並加以解決。
The purpose of the pressure test to becarried out before leaving the factory is to examine the performance and safetyof the high pressure reaction kettle:
Magnetic reaction kettle gas pressure testis done for dry cleaning air, nitrogen or other inert gases. In the course ofthe experiment, there should be safety measures, the experimental unit of thesafety management department should be in the field of supervision andregulation.
Magnetic reaction kettle to do the pressuretest（www.gfanyingfu.com） process is as follows:
In the experiment, the pressure of the ruletest should be boosted to 10%, and the joint part of the welded joint boxshould be checked after 5 minutes.
In the confirmation part without leakageafter continuous experimental pressure boost to rule 50%.
There is no abnormal phenomenon in thecourse of the above process, which will step by step up to 10% step by stepaccording to the experimental pressure of the rule, and keep the pressure for10 minutes. Finally, the design pressure of the high pressure reactor, thepressure to meet the moment to view, check the pressure should adhere to thesame period, if there is a change in the high-pressure reaction tank to confirmthe leak site, should be checked and resolved.
